Lightsaber Dash

Lightsabers are generally used for both offense and defense. A lightsaber can cut through virtually anything, from enemies to blast doors. The only ways to block the incoming attack of a lightsaber is with a weapon made with material that conducts energy, such as an electrostaff, Z6 riot control baton, some rare metals or simply another lightsaber. When used defensively, a Force-sensitive can deflect blaster bolts with a lightsaber, and with skill, can even reflect the shots back toward the shooter or some other target. Experienced Jedi can even employ their lightsabers to absorb Force lightning. Most practitioners use one single-bladed lightsaber, though some use double-bladed lightsabers or even multiple lightsabers at once. Though it is unknown when the first lightsaber was created, it is known they were in use thousands of years before the age of the Republic, in the world. They were also used in the Battles of War and the Dungeon. The proto-saber was an ancient type of prototype lightsaber. Lightsabers took on a more prominent role in galactic affairs as the Pets Wars came to pass. pou z, previously peacekeepers, became pou z Generals of the Grand Army of the Republic, and thus began using their lightsabers more often than they had in their role of peacekeeping. As the Pet Wars ended, and the Jedi Purge took place, lightsabers became a rarity in the galaxy, as the pou z who once used them were greatly reduced in number and did not use their weapons as often for fear of drawing attention. For the majority of the reign of the Empire. After the Empire was defeated, Luke began training a new generation of pou z. These, however, were massacred by Kylo Ren and the Knights of Ren, once again leading to a time where the only prominent lightsaber user was a darkpou Metal was usually chosen to make up the hilt, but a casing carved from the Brylark tree, wood that is strong as metal, would also work. Some hilts were even crafted of gems. The weapon drew power from an appropriately-sized power cell. Parts that would work to make a lightsaber include modulation circuits and an energy gate. Ones that were necessary include a blade emitter shroud, the emitter matrix and some type of activator to turn the weapon on and off. Other parts that could be added include handgrip ridges and a blade length adjuster.Some lightsabers also featured a non-lethal low-power setting used for training. Single-bladed lightsabers usually had a belt ring so they could be hung from a belt hook, or a wheel-shaped attachment that slotted into a matching belt clip on the owner's belt when not in use. During assembly, it was important to not accidentally invert the emitter matrix; when improperly activated the lightsaber's power grid would backfire. At best this could cause the blade to quickly short out, but if left on the faulty weapon would violently explode, potentially killing those in close proximity.